Temptation

[Jeff Hughes]

Thanks,

----- Original Message ----- 
From: "Ken Velez" <kvelez at comcast.net>
To: <discussion at nsrca.org>
Sent: Tuesday, October 12, 2004 4:06 PM
Subject: Re: Temptation


>  Jeff the red stuff you are using is lacquer base putty, it will be
> attacked by the fuel proof paint products we use. What you need is a 2 
> part
> finishing and blending putty. Most of this are  polyester based and you
> might find some problems making it stick to epoxy based materials. Make 
> sure
> you scuff the areas good for proper adhesion. As far a the canopy I use
> epoxy resin mixed with microballons aprox. to a 50/50 mix to make the
> fillet.
>
> Ken
> ----- Original Message ----- 
> From: "Richard Strickland" <richard.s at allied-callaway.com>
> To: <discussion at nsrca.org>
> Sent: Tuesday, October 12, 2004 10:12 AM
> Subject: Re: Temptation
>
>
>> Orland uses some two part automotive polyester 2 part  "Dynatron
>> putty-cote"--fine, very light and strong, fairly inexpensive--but you
> gotta
>> work fast.  Get from automotive paint stores. There are other brands
>> probably just as good--this is what they had the last time he bought it
> and
>> he says they are all pretty similar for the fine,spot stuff.
>>
>> Richard S.--(all normal(and abnormal) disclaimers apply)
>>
>> ----- Original Message -----
>> From: "Jeff Hughes" <jeffghughes at comcast.net>
>> To: <discussion at nsrca.org>
>> Sent: Monday, October 11, 2004 7:09 PM
>> Subject: Temptation
>>
>>
>> > OK, building season is officially here in Southern Indiana. I'm about 
>> > to
>> > start my Temptation. I'm going to leave the primary color white and 
>> > just
>> put
>> > trim colors over the gelcoat. What does everybody use to fill in the
> seam?
>> > I've used that red Bondo stuff (one part). But have had some
> compatibility
>> > problems with it and lusterkote.
>> > Also, if you use canopy glue to glue the canopy to the hatch, what do
> you
>> > use to fill in the gap before painting? same stuff?
>> >
>> > Thanks,
>> > Jeff
>> >
>> > =====================================
>> > # To be removed from this list, go to
> http://www.nsrca.org/discussionA.htm
>> > and follow the instructions.
>> >
>>
>> =====================================
>> # To be removed from this list, go to 
>> http://www.nsrca.org/discussionA.htm
>> and follow the instructions.
>>
>
>
> =====================================
> # To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
> 

=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.