Elev. Pull pull Question

[Daniel J. Hamlett]

Yes
  ----- Original Message ----- 
  From: Bob Pastorello 
  To: discussion at nsrca.org 
  Sent: Friday, November 26, 2004 9:38 AM
  Subject: Re: Elev. Pull pull Question


  Yep.  Same distance OUT from surface.  However, just checking things - again - the elevator that is travelling too far also has the control takeoff about 1/16" further FORWARD relative to the hinge line than the other half.
      Could this do it?

  Bob Pastorello
  NSRCA 199  AMA 46373
  rcaerobob at cox.net
  www.rcaerobats.net


    ----- Original Message ----- 
    From: Tom Hinton 
    To: discussion at nsrca.org 
    Sent: Friday, November 26, 2004 8:07 AM
    Subject: Re: Elev. Pull pull Question


    Are both the horns on the bottom the same distance from the surface, same amount of threads?
      ----- Original Message ----- 
      From: Bob Pastorello 
      To: NSRCA 
      Sent: Friday, November 26, 2004 8:58 AM
      Subject: Elev. Pull pull Question


      May seem obvious, but I could use some help here....setting up my Excelleron, centers are okay, cable tensions are pretty close, centering is good.  Up elevator is fine, on Down elevator, ONE elevator moves farther, but they track together except at the endpoint, as close as I can tell.

      Anyone have suggestions on how I'd fine tune this out...??
      Hope everyone had a great T-day!!

      Bob Pastorello
      NSRCA 199  AMA 46373
      rcaerobob at cox.net
      www.rcaerobats.net

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20041126/a54f01fa/attachment-0001.html