T-plates

[Bob Kane]

I deleted the original note, but someone asked about
references to T-plates for composite firewalls. It is
most likely 1/8" aircraft ply circles glued to the
backside of the firewall to support T-nuts. I just
built a low-tech firewall using 1/64" plywood and
end-grain balsa, I'm including it in my next K-Factor article.

=====
Bob Kane
getterflash at yahoo.com


		
__________________________________ 
Do you Yahoo!? 
Check out the new Yahoo! Front Page. 
www.yahoo.com 
 

=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.