honeycombing foam cores

[Koenig, Tom]

And this can be the difference between legal and not legal!

At our recent team trials, there was frantic activity just before the first flights. It was quite disturbing( for the pilots!) to see so many planes needing an instant weight loss program. The pits were littered with wheel pants, foam packing...batteries, spinners etc etc Anything that could go was removed for those flights.

Moral of the story...keep it light everywhere you can, even if it means a honeycomb job!

Tom

-----Original Message-----
From: discussion-request at nsrca.org
[mailto:discussion-request at nsrca.org]On Behalf Of George Kennie
Sent: Friday, 12 November 2004 8:33 AM
To: discussion at nsrca.org
Subject: Re: honeycombing foam cores


The savings is about an ounce and a half per panel.

Bill Glaze wrote:

> All:
> Since a completed wing panel, (Focus, Hydeout, etc). with servo,
> linkage, Monokote covering, etc. will weigh, typically, less than 16
> ounces, how much weight will be saved by honeycombing a raw foam wing
> panel?  Will it be significant enough to notice in performance?  If you
> honey comb it enough to make a significant weight difference, will it
> possibly weaken the panel leading to in-flight distortion, or possible
> structural failure?  I know it's an individual opinion, but that is what
> I'm looking for here.  Thanks.
> Bill Glaze
>
> Del Rykert wrote:
>
> > I recall Tom Weedon doing an article about it in the "K"
> >
> > del
> >  ----- Original Message -----  From: Mike Hester
> >  To: discussion at nsrca.org
> >  Sent: Thursday, November 11, 2004 10:00 AM
> >  Subject: honeycombing foam cores
> >
> >
> >  Hi Gents,
> >
> >  I am in the process of trying new things, and I have the need to
> > honeycomb a few wing and tail cores. What I am trying to find is a
> > source for a power supply/variac and set up with the probes so I can
> > accomplish this. I seem to remember someone having a home made one
> > that worked well, but of course it's been a while and I can't remember
> > who or what.
> >
> >  Can somebody help me out here?
> >
> >  Thanks,
> >  -Mike
> >
> >
> > =====================================
> > # To be removed from this list, go to
> > http://www.nsrca.org/discussionA.htm
> > and follow the instructions.
> >
> >
> >
>
> =====================================
> # To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.




=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.



************************************************************************
*PLEASE NOTE*  This email and any attachments may
be confidential. If received in error, please delete all
copies and advise the sender. The reproduction or
dissemination of this email or its attachments is
prohibited without the consent of the sender.

WARNING RE VIRUSES:  Our computer systems sweep
outgoing email to guard against viruses, but no warranty
is given that this email or its attachments are virus free.
Before opening or using attachments, please check for
viruses.  Our liability is limited to the re-supply of any
affected attachments.

Any views expressed in this message are those of the
individual sender, except where the sender expressly,
and with authority, states them to be the views of the
organisation.
************************************************************************
==================# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.