Hatori 902

[Scott Pavlock]

  Thanks a bunch Verne!
  _______________________________________________________________
  Scott Pavlock
  586-295-2611

  groups.msn.com/scottspatternpage

  photos.yahoo.com/f3aflyer7
    ----- Original Message ----- 
    From: Verne Koester 
    To: discussion at nsrca.org 
    Sent: Sunday, May 30, 2004 11:43 PM
    Subject: Re: Hatori 902


    Scott,
    Stick a wooden dowel into the inlet of the pipe. When you hit the first baffle, put a mark on the dowel right at the pipe inlet. Pull the dowel out and measure it from the mark to the end that hit the baffle. Good luck!!!

    Verne


      ----- Original Message ----- 
      From: Scott Pavlock 
      To: NSRCA Discussion Page 
      Sent: Sunday, May 30, 2004 7:43 PM
      Subject: Hatori 902


      I was wondering if anyone who is using the Hatori 902 tuned pipe could tell me where the first baffle is because I have been getting different opinions from people. I am running a Webra/Bully 1.45 and have had 4 good runs with the motor. I am looking for more power in uplines so I would like to start tweaking the pipe to get to that point. Prop is a 15.5X12W APC so does anybody have any suggestions on the pipe settings?

      Thanks a lot!
      _______________________________________________________________
      Scott Pavlock
      586-295-2611

      groups.msn.com/scottspatternpage

      photos.yahoo.com/f3aflyer7

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040531/7721f356/attachment.html