Hatori 902

[Verne Koester]

Scott,
Stick a wooden dowel into the inlet of the pipe. When you hit the first baffle, put a mark on the dowel right at the pipe inlet. Pull the dowel out and measure it from the mark to the end that hit the baffle. Good luck!!!

Verne


  ----- Original Message ----- 
  From: Scott Pavlock 
  To: NSRCA Discussion Page 
  Sent: Sunday, May 30, 2004 7:43 PM
  Subject: Hatori 902


  I was wondering if anyone who is using the Hatori 902 tuned pipe could tell me where the first baffle is because I have been getting different opinions from people. I am running a Webra/Bully 1.45 and have had 4 good runs with the motor. I am looking for more power in uplines so I would like to start tweaking the pipe to get to that point. Prop is a 15.5X12W APC so does anybody have any suggestions on the pipe settings?

  Thanks a lot!
  _______________________________________________________________
  Scott Pavlock
  586-295-2611

  groups.msn.com/scottspatternpage

  photos.yahoo.com/f3aflyer7
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040530/a7c6278c/attachment.html