Futaba 9ZAP Problem

[David Harmon]

Ron....you could see if the tx channel is working or not by going to
SYS, SRV and then move the throttle stick and observe the screen for
movement on the throttle channel.

Regards

Dave Harmon
NSRCA 586
K6XYZ[at]comcast[dot]net
Torrance, Ca.

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Ron Van Putte
Sent: Wednesday, May 05, 2004 2:51 PM
To: discussion at nsrca.org
Subject: Re: Futaba 9ZAP Problem



I have received several suggestions and I appreciate them.  However, 
some of the responses indicated that the writer didn't understand the 
problem.  I had a flying system that was working perfectly.  Then one 
day the throttle didn't work.  The first thing I tried was reversing 
channel 3.   I ended up trying a totally untouched model on the 9Z 
(default model).  It didn't improve anything.  Then I tried a different 
transmitter, again with a totally untouched model.  It worked 
perfectly.  I'm still stumped.

Ron Van Putte

> -----Original Message-----
> From: discussion-request at nsrca.org 
> [mailto:discussion-request at nsrca.org]
> On Behalf Of Ron Van Putte
> Sent: Wednesday, May 05, 2004 10:16 AM
> To: discussion at nsrca.org
> Subject: Futaba 9ZAP Problem
>
> All - I have tried everything I can think of and still can't solve a
> problem.  I have a Futaba 9ZAP transmitter and was using it in the PPM
> mode to fly a GWS Slow Stick, using a GWS R4P receiver.  Everything
was
> fine until one day I went to fly the Slow Stick.  The aileron,
elevator
> and rudder servos worked fine, but the motor would not work.  I tried
> everything I could think of, including trying an unused model in the
> 9ZAP.  Nothing worked.  Then I tried a different Futaba 9ZAP
> transmitter and everything worked fine.  Huhhhhh?  Any ideas?
>
> Ron Van Putte
>
> =====================================
> # To be removed from this list, go to
> http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
> =====================================
> # To be removed from this list, go to 
> http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>

=====================================
# To be removed from this list, go to
http://www.nsrca.org/discussionA.htm
and follow the instructions.


=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.