Construction of one piece wings

[PENNISI Peter]

Hi all,
 
 
I am going the build a new wing for my ZN-Line Alliance because the original
is too heavy. I want to build the lightest wing possible. What is the best
way to go about this. I will be using fixed gear this time so retracts are
not a factor. 
 
Is removing foam from the wing advisable (lightening holes in foam prior to
sheeting)?
should I use any spars? (remember one piece wing) if so what should they be
made off and how large.
What glue is recommended? (epoxy - probond etc)
 
The wing will need to hold up to the current F3A schedules.
 
Any tips would be appreciated.
 
 
Regards,
 
Peter
 

***************************** Disclaimer *****************************

The contents of this electronic message and any attachments are intended only for the addressee and may contain privileged or confidential information. They may only be used for the purposes for which they were supplied. If you are not the addressee, you are notified that any transmission, distribution, downloading, printing or photocopying of the contents of this message or attachments is strictly prohibited. The privilege of confidentiality attached to this message and attachments is not waived, lost or destroyed by reason of mistaken delivery to you. If you receive this message in error please notify the sender by return e-mail or telephone.

Thank you.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040505/254127fb/attachment.html