TT Pro 1.20 Question

[Paul Lawrence]

Thanks Mike...

Tom,
I haven't found any specs on the TTR9712. It came in a package deal with the
engine and header.
It's 22" long and about 1 3/4" in diameter. I don't know what the volume is.

----- Original Message ----- 
From: "Tom Hinton" <tph1 at bellsouth.net>
To: <discussion at nsrca.org>
Sent: Tuesday, June 29, 2004 7:12 PM
Subject: Re: TT Pro 1.20 Question


> I just got the one Mike had and was wondering about a pipe for it. What is
> the TTR 9712 pipe?
> thanks
> ----- Original Message -----
> From: "Paul Lawrence" <pwl45 at yahoo.com>
> To: <discussion at nsrca.org>
> Sent: Tuesday, June 29, 2004 6:46 PM
> Subject: TT Pro 1.20 Question
>
>
> > I'm experimenting with a Thunder Tiger Pro 1.20 and wondered if anyone
> knew
> > how the tank should be vented. The manual says to run the fuel pickup
line
> > to the inlet on the pump and connect the pump outlet to the carb. Then
it
> > says, "Never to connect the tube from muffler/pipes pressure nipple to
> fuel
> > tank with this pump system." I'm thinking I just need to run an open
vent
> > line. Does that sound right?
> >
> > Also, any advice on what prop to run?
> > This engine will be in a Tai Ji .60, runnning Pro Pattern 20%, weighting
9
> > lbs and running the TTR 9712 pipe.
> >
> >
> > =====================================
> > # To be removed from this list, go to
http://www.nsrca.org/discussionA.htm
> > and follow the instructions.
> >
>
> =====================================
> # To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>


=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.