Engine RPM and load

[Steven maxwell]

 Yes the pipe would make a difference, it has plenty of pull and ran perfect I was just wandering if there are good #'s for load and heat= RPM.
 Thanks  Steve

Wayne Galligan <wgalligan at goodsonacura.com> wrote:
I bet it has a lot to do with using the muffler.  Lance is using Dave Lockharts repitched props to 15.75x12 prop on his and gets I think above 8000rpm with the Mintor pipe.   Maybe he will chime in here.

Wayne G.
 
----- Original Message ----- 
From: Steven maxwell 
To: discussion at nsrca.org 
Sent: Monday, June 21, 2004 9:26 AM
Subject: Engine RPM and load 


 I'm flying a Mintor 170 with Bolly 590r muffler does great, but I tried a 15 3/4 X 13 3 blade and it only tached 6800 on the ground, it pulled great and slower downlines by a little, my fear is of over heating and loads, even though it didn't show any signs of either, oh all this was do with Coolpower 15% and the temp was in the high 70's, I'm using a 17 X13 normally that tachs at 7600 to 7700.
 Thanks in advance 
Steve Maxwell
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040621/06aceb53/attachment.html