OS 1.60 Issues
JonLowe at aol.com
JonLowe at aol.com
Tue Jun 1 04:46:07 AKDT 2004
Yes, I wwould like to see pictures. What did you use for your header
extension?
Jon Lowe
In a message dated 6/1/2004 7:26:43 AM Central Standard Time,
flyintexan at houston.rr.com writes:
I have the same setup.... I extended the pipe length by another 1/2"
(minimum) and I mounted the kline right against the needle valve (1/2" of tubing -
total) inlet. It is very important that you keep the reg. close to the needle as
well as try to isolate the reg. from hard vibration. I wrap the reg. in a
rubber band. I am running 15%, APC 17x12, hatori header (and header extension).
I still have a hiccup if I fly around a mid-throttle, but quite rare. It's
getting hot here in TX so I've set the motor a bit rich and I'm turning approx.
8000 rpm on the ground. I can send pics of my setup later today if you
like....
(flyintexan at houston.rr.com)
Alot of guys around here in Dist 6 are running the same setup, but using a
perry pump with good success as well.
Hope it helps,
Mark
P.S. I had to lean the low needle until it would barely even start, then
backed off (rich) a 1/4 turn. Now, I prime it, back flip, and its running.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040601/9b0fbd22/attachment.html
More information about the NSRCA-discussion
mailing list