Perry pump question

[Chuck Czarnik]

 Yes.  You can drill the top left hole deeper in the 1.60 of the backplate with a drill bit smaller than the threads.  Go buy OSMG7909, which is the pressure fitting from the 1.60 FI engine.  Of course clean filings out of engine yada yada...

Did this with my 1.60 a couple of years ago... Very clean way for pressure fitting, no worries about # of threads.  HTH, Chuck

-----Original Message-----
From: discussion-request at nsrca.org
To: discussion at nsrca.org
Sent: 7/17/04 11:53 AM
Subject: Perry pump question

Does anyone know if the same nipple used on the OS 160 can be used on
the OS 91 fx in the same manner ie. the top left hole on the backplate?
thanks, Tom



-----------------------------
NOTICE:  The information contained in this electronic mail message
is either attorney privileged and/or confidential information intended
only for the use of the individual or agent responsible to deliver
it to the intended recipient; or, alternately, proprietary information
(trade secret).  You are hereby notified that any dissemination,
distribution or copying of this communication or unauthorized use of the
information herein contained, is strictly prohibited. If you have
received this communication in error, please immediately delete it
from your computer and notify the sender of your receipt of this message. 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040717/3d181708/attachment.html