Header Rise for Focus I

[vicenterc at comcast.net]

I have the same engine in the Focus I.  The header you should use is the 60 mmm

Vicente Bortone
> Eric,
> I am looking at the Mintor 140.  They come with either a 30mm or 60mm rise
> header. 
> 
> Michael
> 
> Original Message:
> -----------------
> From: Henderson,Eric Eric.Henderson at gartner.com
> Date: Tue, 13 Jan 2004 14:39:14 -0500
> To: discussion at nsrca.org
> Subject: RE: Header Rise for Focus I
> 
> 
> It depends upon where the exhaust port is on the engine. The rise is the
> difference between the exhaust port position and where the end of the
> header pipe finishes up.
> 
> Regards,
> 
> Eric.
> 
> -----Original Message-----
> From: discussion-request at nsrca.org
> [mailto:discussion-request at nsrca.org]On Behalf Of
> fishgod at pobox.mtaonline.net
> Sent: Tuesday, January 13, 2004 2:00 PM
> To: discussion at nsrca.org
> Subject: Header Rise for Focus I
> 
> 
> I am picking up a Focus ver. 1 from a local flyer.  I am wondering how much
> rise is need on the header?  Is it dependent on the type engine?  Any help
> would be much apprciated.
> 
> Michael Laggis
> 
> --------------------------------------------------------------------
> mail2web - Check your email from the web at
> http://mail2web.com/ .
> 
> 
> ============# To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 
> 
> 
> --------------------------------------------------------------------
> mail2web - Check your email from the web at
> http://mail2web.com/ .
> 
> 
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#