receiver antenna and wire placement

[John Ferrell]

In my experience the insulation chaffed through and then the wires chaffed
through. Two inches of wire just is not enough to fly on.

John Ferrell
http://DixieNC.US

----- Original Message ----- 
From: "PPandelaers" <ppandelaers at pandora.be>
To: <discussion at nsrca.org>
Sent: Monday, February 23, 2004 2:06 PM
Subject: RE: receiver antenna and wire placement


> Can anyone explain why this is a problem? The antenna-wire is
> plastic-covered.
>
> ;-)
> Patrick
>
>
> -----Oorspronkelijk bericht-----
> Van: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
> Namens ronlock at comcast.net
> Verzonden: maandag 23 februari 2004 17:53
> Aan: discussion at nsrca.org
> Onderwerp: Re: receiver antenna and wire placement
>
> Aong same idea, to keep battery and servo wires from
> chafing against fiberglas and composite materials,
> you can line the fuse area with a sheet of paper.
>
> later, Ron Lockhart
> > It works fine.
> > Take care that the exposed antenna wire cannot chafe against the fiber
> glass
> > fuse, the last pattern airplane I lost sufferred that!
> >
> > John Ferrell
> > http://DixieNC.US
> >
> > ----- Original Message ----- 
> > From: "JonAlan Wise" <wise at alaskalife.net>
> > To: <discussion at nsrca.org>
> > Sent: Monday, February 23, 2004 12:05 AM
> > Subject: receiver antenna placement
> >
> >
> > > Hi all, What is the best way to run the receiver antenna on a
composite
> > > fuse pattern plane? I am building a Temptation, I`m thinking of
putting
> > > the antenna in a tube inside the fuse. Will this work or will it
create
> > > radio reception problems? Any other ideas? Thanks Jon Wise
> > > Anchorage, Alaska
> > >
> > > =====================================
> > > # To be removed from this list, send a message to
> > > # discussion-request at nsrca.org
> > > # and put leave discussion on the first line of the body.
> > > #
> > >
> > >
> >
> >
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
>
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
>


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#