Fw: Judging questions

[jivey61 at bellsouth.net]

 Bob
 Another twist. The 1st masters manouver- stall turn with 1 3/4 roll up 3/4 roll down.If the first radius to vertical is different than the down line radius,is that 1 downgrade or 2 downgrades because neither is equal to the other.In other words which one do you use for the correct radius.I would say the first one is the correct one since the second was not flown the same.The first radius was flown first and the second radius was an attempt to be the same as the first. Again we are playing with words.
My2cents

Jim Ivey
> 
> From: "Bob Pastorello" <rcaerobob at cox.net>
> Date: 2004/08/04 Wed PM 10:10:47 EDT
> To: "NSRCA" <discussion at nsrca.org>
> Subject: Fw: Judging questions
> 
> The paragraph above that one reads..."Partial loops flown as part of the same maneuver must have identical radii."
>     So - my question still stands.....IF all elements MUST be identical, doesn't that CLEARLY mean that the three additional radii following the FIRST radii MUST be the *same* as that first radii?
> 
> Doesn't that mean that the "first loop part" sets the standard of radii for THAT maneuver?
> Somebody help me understand this....Don R. ????
> 
> Bob Pastorello
> rcaerobob at cox.net
> www.rcaerobats.net
> 
> 
>   ----- Original Message ----- 
>   From: Scott Smith 
>   To: discussion at nsrca.org 
>   Sent: Wednesday, August 04, 2004 7:57 PM
>   Subject: RE: Judging questions
> 
> 
>   4. Both complete and partial square loops must  have corners which are constant and identical radii, i.e., the corner loops must be perfect arcs which are equal in size. Any inequality in loop size or defect in circularity should be downgraded in relation to the severity of the defect.
> 
>   I think the key words here are "Any inequality" (and not "Any inequalities to the initial loop segment")
> 
>     -----Original Message-----
>     From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On Behalf Of mike mueller
>     Sent: Wednesday, August 04, 2004 8:34 PM
>     To: discussion at nsrca.org
>     Subject: Re: Judging questions
> 
> 
>     Bob, I totally agree with your point here. Mike
> 

=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.