Jaccio Perfect Switch Harness

[David Harmon]

If the switch fails on the Jaccio regulator, the radio remains on....
I use them in a helicopter and on a pattern plane and they just sit
there and regulate.
It's probably the most reliable thing on the aircraft.

Regards

Dave Harmon
NSRCA 586
K6XYZ[at]comcast[dot]net
Torrance, Ca.

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Nat Penton
Sent: Tuesday, April 20, 2004 6:04 PM
To: discussion at nsrca.org
Subject: Re: Jaccio Perfect Switch Harness

David I don't know what switch Jaccio uses with the harness but I lost
an
airplane using one of the so -called Mil. Spec type ( so called million
cycles ) toggle switches, due to switch failure. The switch was located
in a
minimum vibration position. I would expect Oddino to know what he is
doing
though.     Nat Penton
----- Original Message ----- 
From: "David Wartel" <d.wartel at comcast.net>
To: <discussion at nsrca.org>
Sent: Tuesday, April 20, 2004 7:29 PM
Subject: Re: Jaccio Perfect Switch Harness


> Has anyone had any problems, or know of any, with this switch?
>
> I'm running it with the regulator on six volts, Airtronics receiver,
Hitec
> digitals. Today while flying only the second flight on a Quest, I
completely
> lost the radio conatact for several seconds and nearly lost the plane.
I'm
> trying to isolate what went wrong. This is my first experience using a
six
> volt system and this switch.
>
> Thank you, Dave
>
> =====================================
> # To be removed from this list, go to
http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>

=====================================
# To be removed from this list, go to
http://www.nsrca.org/discussionA.htm
and follow the instructions.


=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.