12/24 volt schematic

[David Harmon]

Hey, that's right Bob..the - wire on the left battery needs to be cut
and the switch needs to be a DPDT to switch both segments.
Open the one on the left and close the one in the center for 24v.
Regards

Dave Harmon
NSRCA 586
K6XYZ[at]comcast[dot]net
Torrance, Ca. 
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Bob Pastorello
Sent: Sunday, April 18, 2004 8:07 PM
To: discussion at nsrca.org
Subject: Re: 12/24 volt schematic
 
Alan - that schematic will place a DEAD SHORT across the 2nd 12volt
battery when closed.  Check that out; as drawn I think there is a
mistake!!!!

Bob Pastorello
rcaerobob at cox.net
www.rcaerobats.net
 
 
----- Original Message ----- 
From: Alan <mailto:alan at countryworkshop.ca>  Hewson 
To: NSRCA <mailto:discussion at nsrca.org>  
Sent: Sunday, April 18, 2004 9:28 PM
Subject: 12/24 volt schematic
 
I have posted a schematic diagram to make your flight box have 12 or 24
volts for your starter. The diagram and design is courtesy of Mike Darr
( mdarr00 at comcast.net )
 
Click on the following link to see drawing.
http://www.countryworkshop.ca/planes/great_ideas.htm
 
Alan Hewson
 
 
 
Laughing is good exercise......It's like jogging on the inside.
 
For all your Picture Framing needs, go to www.countryworkshop.ca
 

 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040418/9abc0bf7/attachment.html