Attaching Cowling

[Rick Wallace]

I'm pretty sure that Pica Glu-it-2 it would work great - it holds to
fiberglass like .... well, really good! 



> -----Original Message-----
> From: discussion-request at nsrca.org
[mailto:discussion-request at nsrca.org]
> On Behalf Of randy10926 at comcast.net
> Sent: Monday, September 08, 2003 9:02 PM
> To: discussion at nsrca.org
> Subject: RE: Attaching Cowling
> 
> Thanks Bob.  I will be trying this idea as soon as I can get to the
hobby
> store.
> 
> I have not had good luck with any of the epoxies.
> 
> Randy Hatfield
> > Randy, I've had the best results using the "black CA" (rubberized, I
> > think they call it).   Thoroughly clean the surface with acetone,
> > roughen, clean again, then apply FRESH ply plates using the black
CA.
> > 	A friend once referred to it's adhesion ability as "like s-@& on
> > an Army blanket" <G>
> > 	And it is a VERY permanent CA, even in high-vibration areas.  As
> > always, YMMV...but this has worked on a number of airplanes, small
and
> > large for me.
> >
> > Bob P.
> >
> > -----Original Message-----
> > From: discussion-request at nsrca.org
[mailto:discussion-request at nsrca.org]
> > On Behalf Of randy10926 at comcast.net
> > Sent: Monday, September 08, 2003 7:00 PM
> > To: discussion at nsrca.org @nsrca.; nvrc club list
> > Subject: Attaching Cowling
> >
> > Well the 1/64 ply backing I have been using at the attachment points
for
> > my
> > colwing keeps coming off.  What glue should I be using and is there
any
> > preparation that I may be missing?
> >
> > Randy Hatfield
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#