Attaching Cowling

[randy10926 at comcast.net]

Thanks Bob.  I will be trying this idea as soon as I can get to the hobby store.

I have not had good luck with any of the epoxies.

Randy Hatfield
> Randy, I've had the best results using the "black CA" (rubberized, I
> think they call it).   Thoroughly clean the surface with acetone,
> roughen, clean again, then apply FRESH ply plates using the black CA.
> 	A friend once referred to it's adhesion ability as "like s-@& on
> an Army blanket" <G>
> 	And it is a VERY permanent CA, even in high-vibration areas.  As
> always, YMMV...but this has worked on a number of airplanes, small and
> large for me.
> 
> Bob P.
> 
> -----Original Message-----
> From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
> On Behalf Of randy10926 at comcast.net
> Sent: Monday, September 08, 2003 7:00 PM
> To: discussion at nsrca.org @nsrca.; nvrc club list
> Subject: Attaching Cowling
> 
> Well the 1/64 ply backing I have been using at the attachment points for
> my 
> colwing keeps coming off.  What glue should I be using and is there any 
> preparation that I may be missing?
> 
> Randy Hatfield
> =====================================
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 
> =====================================
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#