Rudder pull/pull

[Terry Brox]

I found this on RC Universe, forums in the radio section. http://www.rcuniverse.com/forum/searchpro.asp?phrase=oscillation&message=both&topicreply=combined&forumid=116&timeframe=%3E&timefilter=-365&sortmethod=d
  ----- Original Message ----- 
  From: Clay Schmidt 
  To: discussion at nsrca.org 
  Sent: Saturday, November 29, 2003 11:36 PM
  Subject: Re: Rudder pull/pull


  Thanks to all for your replies.

  I took Tom's suggestion and tightened up the cables a bit and it seemed to help but not totally eliminate it.  This servo does have a little slop in the gear train as it has a gazillion miles on it.  It was used in my heli on the collective,  so it's had a good work out, but never has exhibited this behavior.  I've got a few more so I'll swap it out and see what happens.  It probably wouldn't hurt to send it to the doctor for a check up.

  Thanks again,

  Clay


  ----- Original Message ----- 
    From: Clay Schmidt 
    To: discussion at nsrca.org 
    Sent: Saturday, November 29, 2003 9:46 PM
    Subject: Rudder pull/pull


    Hello all,

    I know this subject has been touched on before but I can't remember the solution, so I'm asking again.  

    I'm setting up the rudder pull/pull in my new plane.  I'm using a 8411sa on the rudder.  Everything seems to be fine but I will get an occasional oscillation at neutral. It will stop when I touch the servo arm with my finger, but as soon as I wiggle the stick the oscillation will start again.  Any ideas?

    Thanks,

    Clay Schmidt
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20031130/43395023/attachment.html