Rudder pull/pull

[Clay Schmidt]

Thanks to all for your replies.

I took Tom's suggestion and tightened up the cables a bit and it seemed to help but not totally eliminate it.  This servo does have a little slop in the gear train as it has a gazillion miles on it.  It was used in my heli on the collective,  so it's had a good work out, but never has exhibited this behavior.  I've got a few more so I'll swap it out and see what happens.  It probably wouldn't hurt to send it to the doctor for a check up.

Thanks again,

Clay


----- Original Message ----- 
  From: Clay Schmidt 
  To: discussion at nsrca.org 
  Sent: Saturday, November 29, 2003 9:46 PM
  Subject: Rudder pull/pull


  Hello all,

  I know this subject has been touched on before but I can't remember the solution, so I'm asking again.  

  I'm setting up the rudder pull/pull in my new plane.  I'm using a 8411sa on the rudder.  Everything seems to be fine but I will get an occasional oscillation at neutral. It will stop when I touch the servo arm with my finger, but as soon as I wiggle the stick the oscillation will start again.  Any ideas?

  Thanks,

  Clay Schmidt
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20031129/fd0e3754/attachment.html