Quest 90 3D

[Bill Pritchett]

Earl:
Thanks to you and Eric for posting all this info..... any thoughts on hard/soft mounting?  Do you think the YS 1.10 would benefit much from a pipe?  I have lots of them laying around.
Bill
  ----- Original Message ----- 
  From: Earl Vincent 
  To: discussion at nsrca.org 
  Sent: Saturday, November 29, 2003 8:22 AM
  Subject: Re: Quest 90 3D


  Hi Steve, the only mod I did to put the fuel tank on the cg was to cut out the canopy floor and extend walls up and recap it, a 14 or
  16 oz tank sits right on the cg with this change, other than that I used the stock wood engine beams and gear and all are working
  fine so far with approx 30-40 flights on it. I have some picks of the tank mod if you want to see when building yours. The tank over the cg not a necessity, my Webra 120 is pumped and all the YS engines use pressure but if a standard 90 2c were used the tank
  behind the firewall would work also. Good luck with yours when you get it.
  Earl
    ----- Original Message ----- 
    From: Patternrules at aol.com 
    To: discussion at nsrca.org 
    Sent: Friday, November 28, 2003 8:08 PM
    Subject: Re: Quest 90 3D


     Yes, I did order the Red. Eric or Earl did you make any mods to the Gear or anything, that I may need to know about before I get mine?
     Thanks for the PIC Eric that looks real good with the YS 110 and 90 degree. 
     Didn't know the weights was so much different on the 120s.
     As I have never seen or flown one it sure looks like a very viable product to encourage people to try pattern, for people that wouldn't ever even buying a used plane of the 2 meter size shoot if it does so good I may sell my planes and get all Quest. 


    Thanks
    Steve Maxwell
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20031129/777fd043/attachment.html