140FZ RPM's?: My rpms enclosed

[Tony Stillman]

Gerald:

Lean the idle air bleed first.  Just screw it all the way in, the back it out 4 turns.  Then give another try.  Sounds like you might have to touch the regulator 1/4- 1/2 turn.

Tony Stillman
Radio South
3702 N. Pace Blvd.
Pensacola, FL 32505
1-800-962-7802
www.radiosouthrc.com
  ----- Original Message ----- 
  From: GW 
  To: discussion at nsrca.org 
  Sent: Wednesday, May 21, 2003 3:03 PM
  Subject: Re: 140FZ RPM's?: My rpms enclosed


  Got the chance to run the engine on the 15%CP and the 16x11 APC prop out on the front deck. 
  Here is what I have.
  Peaked engine at 8500. Backed off 2maybe3 clicks to a steady 8300 rpm bumping up to 8400 ever so often.
  Set idle at 1900. It would run at this RPM for quite awhile. I give up waiting on it to quit, so I must be close on the low end.
  Back to idle after another runup at full rpm for 15 seconds or so. Engine went to 1900 and stayed there again. 

  On the next trottle up, it stumbled a bit on its way to full throttle .   When I shut it down there was fuel dripping from the carb. I think rich. Am I right? 
  a bit rich on the bottom at idle, slight stumble to full acceleration,(took it maybe 4 seconds to reach full rpm).
  Alot of smoke all the way through the throttle . 
  If I' m correct on being rich,how much turning on the low speed needle to get it closer to right?

  Will this RPM of 8300-8400 on the CP 15% be a problem?
  I see most like theirs at 86-8800. Will it hurt the engine to lug it at this rpms? I'm sure upping the nitro will also help me with the transition above, as many of you have already recommended .

  Many thanks to all who responded via the list and private emails.

  Gerald Williams
  Email : gw at gwair.com
  Webpage: gwair.com

    ----- Original Message ----- 
    From: jim ivey 
    To: discussion 
    Sent: Wednesday, May 21, 2003 10:40 AM
    Subject: Re: 140FZ RPM's?


    GW
    If I remember right I used YS 20-20 fuel and a 16x10 prop and turned 8200-8400 a little on the rich side.

      ----- Original Message -----
      From: GW
      Sent: Wednesday, May 21, 2003 8:50 AM
      To: discussion at nsrca.org
      Subject: 140FZ RPM's?

      Can anyone let me know what RPM's I should be getting on a 140FZ with a 16x11 APC on CoolPower 15%-20%  ?

      or any RPM figures with this prop on your fuel of choice?





      Gerald Williams
      Email : gw at gwair.com
      Webpage: gwair.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030521/a68fa756/attachment.html