Webra 145

[wgalligan]

Jerry,

Is that a 17x12 wide or 17x12N that your are using?

WG

-----Original Message-----
From: Jerry Budd <jbudd at QNET.COM>
To: discussion at nsrca.org <discussion at nsrca.org>
Date: Sunday, May 04, 2003 1:54 AM
Subject: Re: Webra 145


>Here's my setup:   Webra 145 Aero-X with the MC (mixture control) 
>carb on Magnum #1, OS-F or YS plug, ES-2C140L90 pipe set at 23-1/4" 
>baffle to plug (straight line distance), stock Mac's 2-1/4" rise 
>header, and an APC 17x12 prop.  This combo turns 8600 peak rpm, I fly 
>it at ~8400 rpm.  The same setup on my two OS140Rx's turn 8400 rpm 
>peak, fly at ~8200 rpm (for some reason I seem to have above average 
>motors).
>
>Jerry
>
>>145 on Greaves pipe.  8500 on APC 17-10, 15% Pylon Ritchs Brew.  Is 
>>that good compared to the number you guys are running?
>>
>>Also, I really am running it on more of a 3D plane.  The 17-10 makes 
>>the plane jump, not very smooth.  I would like it to trasition a 
>>little more linear.  What suggestions do yall have for a prop?
>>
>>Thanks,
>>
>>Tony D
>>
>>
>>----- Original Message -----
>>From: <mailto:Eric.Henderson at gartner.com>Henderson,Eric
>>To: <mailto:discussion at nsrca.org>discussion at nsrca.org
>>Sent: Saturday, May 03, 2003 8:40 PM
>>Subject: RE: Webra 145
>>
>>The wrist pin is threaded on the inside. A head bolt will pull it out.
>>
>>Eric.
>>
>>
>>-----Original Message-----
>>From: 
>><mailto:discussion-request at nsrca.org>discussion-request at nsrca.org 
>>[mailto:discussion-request at nsrca.org]On Behalf Of Don Ramsey
>>Sent: Saturday, May 03, 2003 2:24 PM
>>To: <mailto:discussion at nsrca.org>discussion at nsrca.org
>>Subject: Webra 145
>>
>>I'm trying to disassemble my Webra 145 and can't seem to find the 
>>secret to removing the wrist pin and connecting rod.  Sleve is out 
>>but there must be a secret.  Anyone know?
>>
>>DR
>
>
>-- 
>___________
>Jerry Budd
>mailto:jbudd at qnet.com
>=====================================
># To be removed from this list, send a message to 
># discussion-request at nsrca.org
># and put leave discussion on the first line of the body.
>#
>

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#