Webra 145

[Jerry Budd]

Here's my setup:   Webra 145 Aero-X with the MC (mixture control) 
carb on Magnum #1, OS-F or YS plug, ES-2C140L90 pipe set at 23-1/4" 
baffle to plug (straight line distance), stock Mac's 2-1/4" rise 
header, and an APC 17x12 prop.  This combo turns 8600 peak rpm, I fly 
it at ~8400 rpm.  The same setup on my two OS140Rx's turn 8400 rpm 
peak, fly at ~8200 rpm (for some reason I seem to have above average 
motors).

Jerry

>145 on Greaves pipe.  8500 on APC 17-10, 15% Pylon Ritchs Brew.  Is 
>that good compared to the number you guys are running?
>
>Also, I really am running it on more of a 3D plane.  The 17-10 makes 
>the plane jump, not very smooth.  I would like it to trasition a 
>little more linear.  What suggestions do yall have for a prop?
>
>Thanks,
>
>Tony D
>
>
>----- Original Message -----
>From: <mailto:Eric.Henderson at gartner.com>Henderson,Eric
>To: <mailto:discussion at nsrca.org>discussion at nsrca.org
>Sent: Saturday, May 03, 2003 8:40 PM
>Subject: RE: Webra 145
>
>The wrist pin is threaded on the inside. A head bolt will pull it out.
>
>Eric.
>
>
>-----Original Message-----
>From: 
><mailto:discussion-request at nsrca.org>discussion-request at nsrca.org 
>[mailto:discussion-request at nsrca.org]On Behalf Of Don Ramsey
>Sent: Saturday, May 03, 2003 2:24 PM
>To: <mailto:discussion at nsrca.org>discussion at nsrca.org
>Subject: Webra 145
>
>I'm trying to disassemble my Webra 145 and can't seem to find the 
>secret to removing the wrist pin and connecting rod.  Sleve is out 
>but there must be a secret.  Anyone know?
>
>DR


-- 
___________
Jerry Budd
mailto:jbudd at qnet.com
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#