Webra 145

[Don Ramsey]

Jerry,

Thanks, I had removed the clip and did try screwing in backplate screw and
was still unable to get it out and I pulled hard.  I made the post to the
list then went back to work.  Tried the exacto and it worked fine.

Thanks for the help.
Don

----- Original Message ----- 
From: "Jerry Budd" <jbudd at QNET.COM>
To: <discussion at nsrca.org>
Sent: Saturday, May 03, 2003 1:46 PM
Subject: Re: Webra 145


> Hi Don,
>
> You first need to remove the spring clip retainer holding the wrist
> pin into the piston.  Then you use a 4mm screw (one of the back plate
> screws works) and thread it into the wrist pin (it's tapped for this)
> and pull the wrist pin out of the piston.  Usually there is some
> carbon/varnish buildup in the road but that can be scraped out with
> an X-Acto blade.  Be aware that the wrist pin sometimes can take some
> tugging to remove; I've had to grab the screw head with a set of
> ViseGrips before to get a good pull.
>
> Jerry
>
> >I'm trying to disassemble my Webra 145 and can't seem to find the
> >secret to removing the wrist pin and connecting rod.  Sleve is out
> >but there must be a secret.  Anyone know?
> >
> >DR
>
>
> -- 
> ___________
> Jerry Budd
> mailto:jbudd at qnet.com
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#