Finesse 120 Conversion to Fixed Gear

[Michael & Melissa Laggis]

Where did you position the gear? Just in front of the wing or was it a bit
farther back towards the CG?

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On
Behalf Of adriancwong at earthlink.net
Sent: Monday, March 10, 2003 6:15 AM
To: discussion at nsrca.org
Subject: Re: Finesse 120 Conversion to Fixed Gear

Michael,

I have a Finesse 2+2 I still fly from time to time. It started out with
retracts and has since been converted to the Bolly's 60 size fixed gear.

The conversion was real simple. I cut open two holes on both sides of the
fuse for the one piece gear set to slip through, then installed (inside the
fuse) two hardwood wooden blocks on both sides of the pipe tunnel for
mounting the gear set. Finally, as a reinforcement, I installed a pice of
1/8" thick aluminum plate on the flat bottom part of the fuse. The whole
conversion took two evenings to complete. As a matter of fact, I have
converted my Python to a fixed gear also.

Good luck.

Adrian Wong

Chingbergh Enterprises, Inc.
1555 Lakeside Drive, Suite # 194
Oakland, CA 94612
Tel:    (510)452-1005
Fax:    (510)452-0378
E-mail: info at chingbergh.com
www.chingbergh.com





-------Original Message-------
From: Michael & Melissa Laggis <mmlaggis at mtaonline.net>
Sent: 03/10/03 06:44 PM
To: discussion at nsrca.org
Subject: Finesse 120 Conversion to Fixed Gear

>
> Hello All,
How hard would it be to convert an already assembled Finesse 120 from
pneumatic retracts to fixed gear.  Looking at the Bolly USA site I see
they
have 60, 140 Lg. and 140 Wide carbon gear.  Which gear would be most
suitable?  Would I just reinforce the fuse with a 1/4 inch ply at the
first
former?  I think doing this would lighten up the aircraft a bit.  Thanks
for
all your input.

Michael Laggis
Alaska Radio Control Society
<a target=_blank
href="http://www.alaskarc.org">http://www.alaskarc.org</a>


=====================================
# To be removed from this list, send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#

>
=====================================
# To be removed from this list, send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#