Stuck Rear Bearing

[Jerry Budd]

Hi all,

What's the best way to remove a rear bearing that's stuck on the 
crankshaft?  I went to change out the rear bearing on my OS140RX and 
install one of the KSK stainless steel bearings that I have, and I 
had to heat the case in the oven to get the crank out.  When it came 
out, the rear bearing went with it, and now it's stuck on the 
crankshart.  I'm thinking that I'll have to cut it off with a Dremel 
cut-off wheel, but before I did that I was wondering if there were 
any other "tricks" that I might try.

Any ideas?

Thx, Jerry
-- 
___________
Jerry Budd
Budd Engineering
http://www.buddengineering.com
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#