Sheeting wings-Elan

[Rick Wallace]

After you sheet the wings, you should be able to see where to cut just by 
holding the wing panel up to a strong light - you'll be able to see where 
the cuts go.
(Just make sure you cut the sheeting on the BOTTOM of the wing panel -- 
Don't ask me how I know that could be a problem...<g>)

Rick


>Raining here in Houston, so today I'm going to sheet the foam wings on my
>Elan (one of them anyway).  Just wondering about sheeting over the retract
>block and wheel well, & aileron servo mount. Do you just measure their
>location, then after sheeting go back and find them and cut out the
>sheeting?
>
>thanks,
>
>Jerry Wilson
>
>=====================================
># To be removed from this list, send a message to
># discussion-request at nsrca.org
># and put leave discussion on the first line of the body.
>#


_________________________________________________________________
Help STOP SPAM: Try the new MSN 8 and get 2 months FREE* 
http://join.msn.com/?page=features/junkmail

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#