Webra TruTurn Adapter Bushing Problem

[s.vannostrand at kodak.com]

The crank isn't oversised.  The bushing supplied is just too small.
--Lance


Just a thought... if the crank was oversize it would not fit the front 
bearing.

 Alan Simmonds

  -----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On Behalf Of Lee Davis
Sent: 08 January 2003 19:10
To: discussion at nsrca.org
Subject: Re: Webra TruTurn Adapter Bushing Problem

This is a new one I haven't heard of before.  If you don't have any luck 
you can always return the engine to us and we'll check it out.  Look hard 
at the bushings, though.  It's difficult to imagine that out of all the 
Webra engines there's one that's oversized at the crank end.  Anything's 
possible though.

 One likely solution just occured to me.  Try heating the bushing in the 
oven or with a small torch.  The aluminum will expand quite a bit and I'll 
bet it will then slip over the crank.  It's probably not off more than a 
couple of thousandths.

 Lee Davis

Piedmont Models
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030108/019cda75/attachment.html