EconoKote vs. MonoKote

[wgalligan]

I am backing your pardon...

You have been backing up to that camel again havent you Amir?

> What backing???
> 
> Amir
> 
> 
> > I hate to ask...but you did remove the backing from the Momokote......
> > ----- Original Message -----
> > From: "Atwood, Mark" <atwoodm at paragon-inc.com>
> > To: <discussion at nsrca.org>
> > Sent: Thursday, February 13, 2003 1:33 PM
> > Subject: RE: EconoKote vs. MonoKote
> >
> >
> > Hey Paul,
> >
> > I'm a huge advocate for "low" heat...but don't be afraid to use "enough"
> > heat. Balsa is an exceptional insulator (it's heavily used on
> refrigeration
> > ships) so you can use reasonable heat without worrying about the foam.
> Just
> > don't crank the heat to high and hold it in one spot too long or you can
> get
> > a dip.   But moderate heat is more than acceptable, and even high heat on
> > occasion if needed as long as it's not stationary.
> >
> > I've been covering foam wings with Monokote for a long time and never
> melted
> > the foam.
> >
> > Mark
> >
> >  -----Original Message-----
> > From: Paul Reed [mailto:paul at judco.net]
> > Sent: Thursday, February 13, 2003 1:25 PM
> > To: discussion at nsrca.org
> > Subject: EconoKote vs. MonoKote
> >
> > Does anyone out there have any experience using EconoKote for foam core
> > wings? My wing cores are honeycombed and I am having trouble with
> Monokote.
> > The MonoKote especially the white is not adhering well to the balsa even
> > though the surface has been cleaned thoroughly with compressed air and a
> > tack rag. Your advice and experience will be appreciated.
> >
> > Regards,
> > Paul Reed
> > Quality Coordinator
> >
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> >
> > ============# To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> >
> >
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> 
> =====================================
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#