Mintor 1.70

[Lance Van Nostrand]

Eric,
Do you mean a real Bolly, or the Mintor CF pipe.  The Mintor pipe has a
partial baffle at 11.25 and the real plate at 13-5/8
--Lance

----- Original Message ----- 
From: "Henderson,Eric" <Eric.Henderson at gartner.com>
To: <discussion at nsrca.org>
Sent: Monday, August 11, 2003 10:23 PM
Subject: RE: Mintor 1.70


I am a bit confused on the pipe lengths that are being used. I measured my
ES (OS-clone pipe) and the baffle is 13.5 inches from the inlet. The Bolly
pipe that came with my Mintor has the first baffle at 11.25 inches.

With the ES pipe I am at 24.24" from center of head with low rise pipe. What
I was going to do was use the Bolly but elected to use the ES because it had
an integral stinger/diverter.

If I now fit the Bolly I am thinking that I am going to be way-off in pipe
length, Any experience out there with the Bolly and this header on a 1.70
Mintor?

Regards,

Eric.


-----Original Message-----
From: discussion-request at nsrca.org
[mailto:discussion-request at nsrca.org]On Behalf Of rcaerobob at cox.net
Sent: Monday, August 11, 2003 11:49 AM
To: discussion at nsrca.org
Subject: Re: Mintor 1.70


HO-LY-COW !  That's a pretty beefy setup, for sure.  10% Nitro?  You're
kiddin', right??

Bob P.
>
> From: "Wayne Galligan" <wgalligan at goodsonacura.com>
> Date: 2003/08/11 Mon AM 11:27:50 EDT
> To: <discussion at nsrca.org>
> Subject: Mintor 1.70
>
> Just a few notes on my initial test and break-in on this engine.  It has
not been installed in my plane as of this writing but I cant wait.
>
> 3M 1.70 stock header
> 10 % Magnum fuel
> Bluebird c.f. 2-stroke pipe  24.25" center of head to 1st baffle.  Total
length of exhaust center of head to end of pipe  31.5"
>
> Test day 98 degrees and about 35%+ humidity
>
> 17x12N APC      high 8500rpm low 1600rpm
> 17x13 std APC   high 8250rpm  low 1500rpm
>
> This is after 5) 16oz tanks of breakin.  I broke it in just like the OS,
alternating rich to lean during first several tanks.
>
> Wayne Galligan
>
>

Bob Pastorello, El Reno, OK, USA
rcaerobob at cox.net
www.rcaerobats.net
============# To be removed from this list, send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#