Ultimate 10-300

[John Crozier]

My Ultimate is 10lbs., with a YS120AC. Turns 8100 with a 16x8 apc. Stock
muffler.
Flys slowly, with much vertical.
I have had it out only once since I became hooked on pattern.
I guess I should sell it...............croz


----- Original Message -----
From: "Earl Vincent" <ev3464 at sccoast.net>
To: <discussion at nsrca.org>
Sent: Wednesday, April 23, 2003 4:33 AM
Subject: Re: Ultimate 10-300


Hi John, I have a Goldberg Ultimate with a pumped Webra 120 w/pitts muffler,
any suggestions on a prop size, the model weight
is 9.2 Lbs. I flew it with an APC 14/12 and the engine was turning 8700,
flew ok but not much vertical, are you running anything in
this size, would appreciate any input.
Earl Vincent
Myrtle Beach, SC
  ----- Original Message -----
  From: RcAddict
  To: discussion at nsrca.org
  Sent: Monday, April 21, 2003 8:15 AM
  Subject: Re: Ultimate 10-300


  Hi Larry
  I'm not a pattern flyer but I've had two Ultimates the 1/4 scale Goldberg
with a 120 and a 27% Ohio rc with a 50cc gasser . They both flew much the
same they like to tip stall at low throttle settings you have to keep the
speed up on landing and fly it to the ground. They are a hoot to fly though
they do the most intense snaps of any airplane I've ever flown. I would
suggest you get rid of as much weight as possible I know that's easier said
that done. Anyway good luck.
  John L.
    ----- Original Message -----
    From: jed241 at msn.com
    To: NSRCA
    Sent: Friday, April 18, 2003 12:45 PM
    Subject: Ultimate 10-300


    This isn't a pattern topic, but I'm certain that many will share
opinions, good / bad.<VBG>

    Any thoughts on a Quadrotech 1/4 Scale Ultimate 10-300? I'm getting one
at a good price.

    Web-Site:  http://www.arcdirect.com/quadrotech/ultimate.htm

    Any inherent problems with the kit, any mods to make it better /
lighter?

    I'm looking at a YS 1.40DZ w/ 3-bladed prop, is this enough power if it
come out at 11.5lbs and who makes a Pitts muffler for it? What size prop
would be used for a 3-bladed set up?

    The stab is 1/4" balsa slab and/or stick I think, would it be beneficial
to have foam cut for an airfoil stab and rudder?

    I appreciate your thoughts, even if it's to sell it real fast.lol

    Larry
    NSRCA 3083
    AMA 5024


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#