SERVO GEARS

[Tomanek, Wojtek]

Troy 

What are the nylon conversion gears for the 8411?

TIA
Wojtek


 -----Original Message-----
From: 	Troy Newman [mailto:troy_newman at msn.com] 
Sent:	Wednesday, April 16, 2003 2:48 PM
To:	discussion at nsrca.org
Subject:	Re: SERVO GEARS

JRPSG911 is the part number for the 911 gear sets...These are the proper
gears to be using in the 9411 is converting to nylons.
The regular 9411 gears are fine....you don't need to change them until they
get sloppy...The metal gears on average will go over a hundred
flights...where as the nylons I have seen go much longer....as in 200+
flights without any noticeable wear.
If the 911 gears are out of stock the 9411 gears may be available  part #
JRPSG9411

I have run these servos a bunch..and the 9411's are a great Aileron
solution.....Don't think just because they are metal gears they need to be
changed out to nylons....I flew a set last year that was metal setup for
most of the year...At the same time I was running nylon converted versions
in another model....After the NATS I switched the metal ones to Nylon
conversions..... 
Performance is equal...life span of the gears is less with the metal gear
servos all metal gear servos.
If you are down and out of flying look for a set of 9411 metal gears.
Sorry I don't have any gear sets at the moment.....
Troy Newman


----- Original Message -----
From:	"wgalligan" <wgalligan at cnbcom.net>
To:	<discussion at nsrca.org>
Sent:	Wednesday, April 16, 2003 11:27 AM
Subject:	SERVO GEARS


> Does anyone have any nylon servo gears that will fit in the JR9411 mid
servo.  The metal gears in mine have gotten sloppy to the point of not
trusting them.
>
> I ordered some several weeks ago but the LHD said they where on back
order.
> I need enough for two servos.   Will pay for them or replace them when
mine come in.
>
> Thanks,
> Wayne
>
> BTW WACO contest is 10 days away......
> ====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
>
====================================
# To be removed from this list, send a message to #
discussion-request at nsrca.org # and put leave discussion on the first line of
the body.
#
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#