feather cut

[spbyrum]

Does it cut carpets, too :<)  Couldn't resist.
 
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Amir Neshati
Sent: Thursday, April 03, 2003 2:35 AM
To: discussion at nsrca.org
Subject: Re: feather cut
 
I've cut small and large stuff with Feather Cut.....works great...Just
follow the instructions.
Matt's suggestions are in there too...I don't have any issues with the
supplied wheel. I just
do a few dry runs with the bow (as recommend in the instructions ;-) to
make sure it follows
the correct path before doing the real cut.....Did I mention the
instructions work ;-)
 
Good luck,
Amir
----- Original Message ----- 
From: spbyrum <mailto:spbyrum at hiwaay.net>  
To: discussion at nsrca.org 
Sent: Wednesday, April 02, 2003 4:06 PM
Subject: RE: feather cut
 
Thanks, Matt.  I have not tried that, but it sure sounds easier than the
way I was trying.
 
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Rcmaster199 at aol.com
Sent: Wednesday, April 02, 2003 5:21 PM
To: discussion at nsrca.org
Subject: Re: feather cut
 
In a message dated 4/2/2003 12:51:25 PM Eastern Standard Time,
spbyrum at hiwaay.net writes:




Subj:RE: feather cut 
Date:4/2/2003 12:51:25 PM Eastern Standard Time
From:spbyrum at hiwaay.net
Reply-to:discussion at nsrca.org
To:discussion at nsrca.org
Sent from the Internet 



Brian

Try a larger harder wheel.  I'm trying to learn, too.  Wings are not too
bad.  Stabs ok, too.  I tried cutting a vertical fin.  That didn't go
very well.  The big difference between root and tip along with the very
short span make it very challenging.

Steve Bryum


Steve,

There should be a way to use simple geometric principles to cut a very
sort span, highly tapered wing such as a fin. Have you tried anchoring
one end of the bow down, and only moving the other in a circular
fashion. The anchored end will basically serve as the center of the
circle. Depending on where you place the foam blank within the circle,
you should be able to cut a very high taper and short span wih extreme
accuracy.

BTW, this is true for all tapered wings, except it becomes somewhat
impractical for wide chord wing tips, because the circle center is
sometimes 10 feet away from where the cut is made.

Just an idea for you to mull over

Matt Kebabjian
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030403/e893af05/attachment.html