feather cut

[Amir Neshati]

Sorry, that would be "recommended".... :-(

Amir
  ----- Original Message ----- 
  From: Amir Neshati 
  To: discussion at nsrca.org 
  Sent: Thursday, April 03, 2003 12:34 AM
  Subject: Re: feather cut


  I've cut small and large stuff with Feather Cut.....works great...Just follow the instructions.
  Matt's suggestions are in there too...I don't have any issues with the supplied wheel. I just
  do a few dry runs with the bow (as recommend in the instructions ;-) to make sure it follows
  the correct path before doing the real cut.....Did I mention the instructions work ;-)

  Good luck,
  Amir
    ----- Original Message ----- 
    From: spbyrum 
    To: discussion at nsrca.org 
    Sent: Wednesday, April 02, 2003 4:06 PM
    Subject: RE: feather cut


    Thanks, Matt.  I have not tried that, but it sure sounds easier than the way I was trying.

     

    -----Original Message-----
    From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On Behalf Of Rcmaster199 at aol.com
    Sent: Wednesday, April 02, 2003 5:21 PM
    To: discussion at nsrca.org
    Subject: Re: feather cut

     

    In a message dated 4/2/2003 12:51:25 PM Eastern Standard Time, spbyrum at hiwaay.net writes:





    Subj:RE: feather cut 
    Date:4/2/2003 12:51:25 PM Eastern Standard Time
    From:spbyrum at hiwaay.net
    Reply-to:discussion at nsrca.org
    To:discussion at nsrca.org
    Sent from the Internet 



    Brian

    Try a larger harder wheel.  I'm trying to learn, too.  Wings are not too
    bad.  Stabs ok, too.  I tried cutting a vertical fin.  That didn't go
    very well.  The big difference between root and tip along with the very
    short span make it very challenging.

    Steve Bryum



    Steve,

    There should be a way to use simple geometric principles to cut a very sort span, highly tapered wing such as a fin. Have you tried anchoring one end of the bow down, and only moving the other in a circular fashion. The anchored end will basically serve as the center of the circle. Depending on where you place the foam blank within the circle, you should be able to cut a very high taper and short span wih extreme accuracy.

    BTW, this is true for all tapered wings, except it becomes somewhat impractical for wide chord wing tips, because the circle center is sometimes 10 feet away from where the cut is made.

    Just an idea for you to mull over

    Matt Kebabjian
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030403/74bc4397/attachment.html