BEARING REPLACEMENT

[Tony Stillman]

You did remove the cam gear, right?

Tony Stillman
Radio South, Inc.
3702 N. Pace Blvd.
Pensacola, Fl 32505
www.radiosouthrc.com
800-962-7802
----- Original Message ----- 
From: "Terry Terrenoire" <amad2terry at juno.com>
To: <discussion at nsrca.org>; <pattern at rcmailinglists.com>
Sent: Wednesday, September 25, 2002 9:15 PM
Subject: BEARING REPLACEMENT


> I have a YS 91 fully disassembled....except for getting the crank shaft
> out of the case so I can remove the bearings!
> I have been trying to get it out by "tapping" it with a plastic hammer,
> but have only been able to move it ablut 1/8th inch.
> Any suggestions would be greatly appreciated. Maybe I should just send
> the case to Pervormance Products and let Rich do it!
> 
> Terry T.
> =====================================
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 
> 


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#