BEARING REPLACEMENT

[Thomas C. Weedon]

Terry,
I have always set the crankcase in the oven at 250 deg F for about 30 min.
then take it out, set the crankcase down on a wooden cutting block and tap
the crank shaft with a rubber or plastic hammer. It always dropped out
immediately.
Tom

-----Original Message-----
From: discussion-request at nsrca.org
[mailto:discussion-request at nsrca.org]On Behalf Of Terry Terrenoire
Sent: Wednesday, September 25, 2002 10:15 PM
To: discussion at nsrca.org; pattern at rcmailinglists.com
Subject: BEARING REPLACEMENT


I have a YS 91 fully disassembled....except for getting the crank shaft
out of the case so I can remove the bearings!
I have been trying to get it out by "tapping" it with a plastic hammer,
but have only been able to move it ablut 1/8th inch.
Any suggestions would be greatly appreciated. Maybe I should just send
the case to Pervormance Products and let Rich do it!

Terry T.
=====================================
# To be removed from this list, send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#