The MASTERS 2005 PROPOSED ROUTINE THAT YOU VOTED FOR.
Henderson,Eric
eric.henderson at gartner.com
Wed Sep 25 10:23:56 AKDT 2002
Any K Factor rating experts out there, please wade in..
Eric.
-----Original Message-----
From: Tomanek, Wojtek [mailto:tomanekw at saic-abingdon.com]
Sent: Wednesday, September 25, 2002 2:21 PM
To: 'discussion at nsrca.org'
Subject: RE: The MASTERS 2005 PROPOSED ROUTINE THAT YOU VOTED FOR.
Should the maneuver # 9 (9. Half Inside Loop, 2/4 on exit K=1) be rated
K=2, comparing to an Immelman which is K=2?
WKT
-----Original Message-----
From: Henderson,Eric [SMTP:eric.henderson at gartner.com]
Sent: Wednesday, September 25, 2002 12:27 PM
To: Discussion at Nsrca. Org
Subject: The MASTERS 2005 PROPOSED ROUTINE THAT YOU VOTED
FOR.
2005 Masters proposal.
1. Takeoff (U) K=1
2. Stall Turn 1 ¼ Rolls Up, ¾ Roll Down, Exit Inverted (U) K=4
3. Half Outside, 2/4 K=2
4. Reverse Avalanche with 1 positive snap @ Bottom (D) K=4
5. 1/2 loop with full Roll Out K=2
6. 45 degree Pyramid Loop with Half Rolls (U) K=4
7. Humpty Bump, ¼ Roll Up, ¾ Roll Down K=3
8. Quarter, Half, Quarter Roll (D) K=4
9. Half Inside Loop, 2/4 on exit
K=1
10. Square Eight from the Middle, Pilot's Option (U)
K=4
11. Figure nine - pull loop first, 1/2 roll down
K=3
12. Slow Roll (D) K=3
13. Pull-Push Humpty Bump with Pilot's Option K=2
14. Square Loop with 2/4 Rolls on all side (U) K=5
15. Stall Turn With Half Rolls K=2
16. Inside-Outside Diamond Eight with Full Rolls (D)
K=5
17. Immelmann Turn K=2
18. 45 Degree Down, Positive Snap Roll (U) K=3
19. Top Hat with ¾ Roll Up, ¼ Roll Down, Exit Upright K=3
20. Knife-edge to knife-edge (D) K=4
21. Half Square Loop with 1/2 Roll Up K=2
22. Spin, 2 1/2 Turns, Half Roll Out, Exit Upright (U) K=4
23. Landing (U) K=1
====================================# To be removed from this list,
send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#
====================================# To be removed from this list, send a
message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#
==================# To be removed from this list, send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#
More information about the NSRCA-discussion
mailing list