Questions / Help for a Friend

[Emory Schroeter]

As someone pointed out, you can't use the pump carb without the pump. I
don't think there is any fuel draw from that carb. But, you could order a
standard carb and use the pump if you need to. I think the two screws should
work fine to mount the carb to the engine.

Emory Schroeter.

----- Original Message -----
From: "Larry Diamond" <jed241 at email.msn.com>
To: "NSRCA List" <discussion at nsrca.org>
Sent: Tuesday, September 24, 2002 12:13 AM
Subject: Questions / Help for a Friend


> 1) Does a Perry Pump-Carb (PPC) Series 75  require a pump to operate
> properly, or can it use muffler pressure?
>
> 2) Where can someone find a used carb for an Enya SS .40 2-Stroke? Please
> e-mail me at jed241 at msn.com
>
> 3) Magic question, if #1 is, "Muffler pressure is fine"; is it possible to
> use the PPC Series 75 carb for the Enya SS .40? If so, what's the best way
> to mount it to the engine? The motor is set up for two screws and I'm
> thinking that the carb is designed for a draw pin (1/16" plastic wall for
> the neck of the carb).
>
> Thanks,
>
> Larry
> NSRCA 3083
> AMA 5024
>
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
>


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#