Adhesives for polyester? fuse.

[Zapata, Lisandro A.]

Or... you can use aeropoxy by BVM www.bvmjets.com go to tools & supplies and
look for aeropoxy

Art.

-----Original Message-----
From: David Harmon [mailto:k6xyz at attbi.com]
Sent: Monday, September 23, 2002 2:49 PM
To: discussion at nsrca.org
Subject: RE: Adhesives for polyester? fuse.


Mark...GE Silicone ll Household glue works great for formers, servo
mounts etc.
Those poly fuses are hard to glue to. Some of the newer ZAP products may
be good
too but I haven't tried them. Just don't use PFM or any glue that has
'Goop' or 'Goo'
in the name. That stuff has a reaction with and makes a bump or line on
the poly and epoxy fuselages.
Some guys use the GE stuff on the firewalls too...just make a fillet on
the front and back.
	Dave

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of DrMarkMD at aol.com
Sent: Monday, September 23, 2002 11:11 AM
To: discussion at nsrca.org
Subject: Adhesives for polyester? fuse.


I recently finished a piorun Oly Medal.   I have had several glue joints
pop. 
  At the field one of the med sait I should have used CA.   The epoxy
that I 
used was 2 hour Bob Smith mixed with silica filler. I cleaned the fuse
with 
acetone and sanded the areas to be glued with 80 grit cloth.  I didnt
stress 
the jopints for grreater than 48 hours.  

Is there a Best way to glue polyester Fuses pieces into place?

Mark L.
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#



=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#