Plugs

[Bill Glaze]

Dave:
Wilco.........just tried the one nearest me, which I usually use.  I'll try
another one or two.  But........this store's display sure looked
official......new and neat.
Sure hope they haven't phased out the old ones.  I'll try tomorrow and get
back to the list, for any who might be affected.

Bill Glaze


David Harmon wrote:

> Bill...try a different Rat Shack...all those stores are not the same.
>         Dave
>
> -----Original Message-----
> From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
> On Behalf Of Bill Glaze
> Sent: Friday, October 25, 2002 2:19 PM
> To: NSRCA discussion
> Subject: Plugs
>
> All:
> I was surprised to find out a day or so ago, that the local Radio Shack
> no longer has the plugs used to  make power cords for my Litco charger.
> They now have plugs that are 90 degree, 2 piece, which are (surprise!!)
> much more expensive than the older plugs with the black Bakelite shield.
>
> While these new plugs seem to offer an easier out for soldering, (they
> have 2 wire leads) they also have the possibility of an easy done
> accidental polarity reversal. Anybody else had this problem recently?
> As cheap as the former plugs were, if one could master the trick of
> small part soldering, they worked well. Just an advisory:  If your Radio
> Shack has any of the older plugs, I'd sure buy them all up before some
> Hoarder gets them!  (If you like them as much as I do.)
>
> Bill Glaze
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#