Trim Chart at NSRCA website

[Ihncheol Park]

Hi, All,
I am still trimming my pattern plane. So far, it has 20 flights.
I was browing the NSRCA site and found these.

1. Decalage, Angle of Incidence: Power off vertical dive from high altitude
with elevator neutral.
  B: Model pulls to canopy >> Increase wing or stab incidence??
   I think it has to be decrease wing or increase stab incidence.

  C: Model pulls to belly >> Reduce wing or stab incidence??
   I think it has to be increase wing or decrease stab incidence.

2. Knife Edge Pitch: Normal pass roll to knife edge, left & right, use
rudder to hold model level.
  B: model pitches to canopy >> Move CG aft, increase wing incidence, or mix
down elevator w/ Rudder.

   Isn't this supposed to be move CG aft, decrease wing incidence, or mix
down elevator w/Rudder?

Am I right? If not, can anyone clarify these?
Thanks,


Ihncheol Park
CompTIA A+ COMP10648565
1973 White Ave., #402
Moscow, ID 83843
(208) 883-7882 (home)
(208) 661-5018 (cellular)
PatternFlyer at msn.com

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#