2005 Masters

George Kennie geobet at gis.net
Tue Oct 1 16:29:31 AKDT 2002



Anthony Romano wrote:

> Hi Eric,
> Two questions
>
> >Stall Turn 1 and 1/4 Rolls up, 3/4 Roll down, Exit Inverted
> >Model pulls through one-quarter (1/4) loop to vertical flight,
> >pauses, performs one-and-one-quarter (1-1/4) rolls,
> >pauses, performs a 180 degree stall turn in the direction
> >of the maneuver to a vertical dive, pauses, performs
> >a three-quarter (3/4) roll in opposite rotation, pauses, then pushes
> >through one-quarter (1/4) loop to recover in inverted level
> >flight.
> >Downgrades:
> >1. Track not vertical at beginning and end of rolls
> >and stall turn.
> >2. Track of stall turn not 180 degrees.
> >3. Over or under rotation of rolls. 1 Point per 15
> >Degree Rule.
> >4. Rolls not centered in vertical lines.
> >5. Loop segments not round and of equal radius.
> >6. Pendulum movement after stall.
> >7. Exit not same altitude and heading as entry.
> >8. Roll rates not constant.
> >
>
> Sorry, I took my rule book out of my briefcase so I can't look this up my
> self. There was a question at the judging seminar earlier this year about
> less than 180 degrees of track when wind corrected. Has this been resolved
> or specified in another section?
>
> >>
> >Inside-Outside Diamond Eight with 1/1, Full Rolls, on center 45's
> >Model passes through center and pulls one eighth (1/8) loop to
> >45 degree up line, draws another straight line then pulls quarter (1/4)
> >loop, draws straight line and pulls one quarter loop (1/4). Model hesitates
> >and performs one roll (1/1), hesitates and pushes one quarter loop (1/4) to
> >45 degree up line, draws line and then pushes one quarter loop (1/4), draws
> >straight line, pushes one quarter loop (1/4), hesitates and performs one
> >roll (1/1), hesitates pulls one-eighth loop (1/8) to level flight.
> >Downgrades.
> >
>
> <<<<I think you need another pull quarter loop after the role or you wind up
> on
> a verticle downline.>>>>

I arrive at the same conclusion, Anthony.Georgie

>
>
> Anthony
>
> _________________________________________________________________
> MSN Photos is the easiest way to share and print your photos:
> http://photos.msn.com/support/worldwide.aspx
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #



=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#



More information about the NSRCA-discussion mailing list