C/F wing tubes

[ARQ.FRANCISCO GONZALEZ FLORES.]

Hi Terry
thanks , thanks ,thanks!
francisco
  ----- Original Message ----- 
  From: Terry Brox 
  To: discussion at nsrca.org 
  Sent: Monday, November 18, 2002 7:32 AM
  Subject: Re: C/F wing tubes


  Hi Francisco,
               Lamar Blair and Jerry Stebbins have RC Enterprises. http://home.att.net/~rc-enterprises/rcme_001.htm 
  Their phone is:                256-350-4741 or 256-351-8445 
  Good luck, Terry

    ----- Original Message ----- 
    From: PROESCO-ARQ. FRANCISCO GONZALEZ 
    To: discussion at nsrca.org 
    Sent: Sunday, November 17, 2002 11:38 PM
    Subject: RE: C/F wing tubes


    hi Terry!
    where i can contact to Lamar?? i'm interested in the wing tubes
    thanks
    francisco
      -----Mensaje original-----
      De: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]En nombre de Terry Brox
      Enviado el: Domingo, 17 de Noviembre de 2002 10:34 p.m.
      Para: discussion at nsrca.org
      Asunto: Re: C/F wing tubes


      Dan,
            I am using one of Lamar's C/F wing tubes and just cut a piece of PVC pipe, cut a small piece out, collapsed it into the tube and "Zapped" it in place. I then drilled and tapped for 6 32. I have quite a bit of time on this set up and no sign of stress yet. I also, and always have, tapped the hard point in the wing so there is a lot of "threads" all the way through. 
            Also, Lamar sells a really neat nylon insert that fits his tubes perfectly. 
                                  Happy building,  Terry
        ----- Original Message ----- 
        From: Dan Curtis 
        To: discussion at nsrca.org 
        Sent: Sunday, November 17, 2002 4:39 PM
        Subject: C/F wing tubes


        When using a carbon fiber wing tube can a person use the screw hold down in the wing method or are we limited to using wing holds in the fuselage?  In other words can a small block of wood be placed in each end of the tube and then the tube and wood block be drilled for a 4/40 screw (self tapping) or is the carbon fiber to prone to crack at the drilled hole??

        Thanks
        Dan
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20021118/bc08449e/attachment.html