[NSRCA-dist8] [External] Re: Radio set-up

Mon Oct 25 14:36:20 AKDT 2021

Hey, I’m kind of a big guy! I probably meant Pat has more dexterity. 🤟

Sent from my iPhone

> On Oct 25, 2021, at 3:11 PM, Patrick Harris <harris7148 at gmail.com> wrote:
> 
> That’s a mighty big word!! 👍 Ambidextrous! 
> 
> Sent from my iPhone
> 
>>> On Oct 25, 2021, at 3:31 PM, Bob Crump <bob.crump at yahoo.com> wrote:
>>> 
>> The trick is “getting used to it”. I think everyone is different and I fly with a different tray setup than Pat does and sometimes finding the right switch is a challenge. As another suggestion if you have any IMAC guys in your area ask one of them how they set up their switches, rates, mixing, expo etc. I’ve always subscribed to the keep it simple approach I’m not as ambidextrous as Pat.
>> 
>> 
>> Sent from my iPad
>> 
>>>> On Oct 25, 2021, at 10:45 AM, Patrick Harris <harris7148 at gmail.com> wrote:
>>>> 
>>> 
>>> Once you get used to switches it becomes second nature. I always put my rate switch just above my right stick (mode 2). As soon as I do a snap roll, I turn the switch off with a flick of the back of my index finger. It's also in the perfect position for turning it off for the spin again with a fast flip of the index finger. 
>>> 
>>>> On Mon, Oct 25, 2021 at 11:40 AM Patrick Harris <harris7148 at gmail.com> wrote:
>>>> Karl,
>>>> 
>>>> For spins I switch to full up and down elevator. I flip the switch before spin entry to be able to get the nose up for the stall. Once it stalls and the nose drops, I flip the switch off as I don't want the full elevator for the spin. I spin at normal flying rates. 
>>>> 
>>>> For snaps, I want full or close to full aileron, a hair less rudder and elevator from normal flying rates. 
>>>> 
>>>> For Advanced you will be fine with just dual rates, one for snaps and maybe one for spin entry. You will only have to flip one switch one or two times at most in Advanced. 
>>>> 
>>>>> On Mon, Oct 25, 2021 at 11:09 AM Lyle Laughery via NSRCA-dist8 <nsrca-dist8 at lists.nsrca.org> wrote:
>>>>> I use three switches, one for down elevator for right rudder ,point and slow roll and one for high rate elevator for spin and then switch both of for landing.Then final switch for throttle cut after landing.
>>>>> 
>>>>>> On Mon, Oct 25, 2021 at 9:59 AM Bob Crump via NSRCA-dist8 <nsrca-dist8 at lists.nsrca.org> wrote:
>>>>>> I’ve tried all the above, rate switching, mode switching and I invariably forget to flip the switch. I’m in Jim’s camp now. After several flights on a new airplane I put in enough exponential to get a satisfactory snap and go with it. One change recently was to switch out any mixing when setting up for landing. I even forget that sometimes. I would use whatever your most comfortable with, Switching versus expo.
>>>>>> Regards, Bob 
>>>>>> 
>>>>>> Sent from my iPhone
>>>>>> 
>>>>>>>> On Oct 25, 2021, at 9:40 AM, Karl Watts via NSRCA-dist8 <nsrca-dist8 at lists.nsrca.org> wrote:
>>>>>>>> 
>>>>>>> 
>>>>>> 
>>>>>>> Thanks for feedback Pat and Jim.  Maybe should give more information.  Looking at moving to Advanced next year.  Snaps and spins will be new.  Trying to determine which will be better a rate switch or flight condition switch.  Guess I will need to try them and figure it out, but does not hurt to know what others are doing.    (Pat, just discovered the Phase Set on my Graupner MZ-24 this weekend)  Also what kind of throws do you use between normal flight, snaps and spins?
>>>>>>> 
>>>>>>>  
>>>>>>> 
>>>>>>> From: Patrick Harris <harris7148 at gmail.com> 
>>>>>>> Sent: Monday, October 25, 2021 9:21 AM
>>>>>>> To: Karl Watts <Karl.Watts at saintalphonsus.org>; AK, ID, MT, OR, WA, WY <nsrca-dist8 at lists.nsrca.org>
>>>>>>> Cc: Sean Mersh <mershs at hotmail.com>; James HILLER <jnhiller at comcast.net>
>>>>>>> Subject: [External] Re: [NSRCA-dist8] Radio set-up
>>>>>>> 
>>>>>>>  
>>>>>>> 
>>>>>>> Warning:  This email originated from the Internet!
>>>>>>> 
>>>>>>> DO NOT CLICK links if the sender is unknown, and NEVER provide your password.
>>>>>>> 
>>>>>>> I use both. I use a rate switch for snaps and spins. I use a condition switch (Phase Set in Graupner MZ32 and MZ16) Phase set will allow different servo sub trims and end points. For instance.....I use a Phase Set called "Landing". When I flip that (Landing) switch. it removes the down elevator to low throttle mix, gives me a hair of up elevator trim, and increases the up elevator throw a bit. Phase Set is like having two radios in one (at least that's how the MZ32 and MZ16 work). Your Mileage May Vary. 
>>>>>>> 
>>>>>>>  
>>>>>>> 
>>>>>>> On Mon, Oct 25, 2021 at 8:31 AM Karl Watts via NSRCA-dist8 <nsrca-dist8 at lists.nsrca.org> wrote:
>>>>>>> 
>>>>>>>  
>>>>>>> 
>>>>>>> Rate switch or flight condition switch?
>>>>>>> 
>>>>>>> 
>>>>>>> Confidentiality Notice:
>>>>>>> This e-mail, including any attachments is the property of Trinity Health and is intended for the sole use of the intended recipient(s). It may contain information that is privileged and confidential.  Any unauthorized review, use, disclosure, or distribution is prohibited. If you are not the intended recipient, please delete this message, and reply to the sender regarding the error in a separate email.
>>>>>>> 
>>>>>>> _______________________________________________
>>>>>>> NSRCA-dist8 mailing list
>>>>>>> NSRCA-dist8 at lists.nsrca.org
>>>>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-dist8
>>>>>>> 
>>>>>>> 
>>>>>>> Confidentiality Notice:
>>>>>>> This e-mail, including any attachments is the property of Trinity Health and is intended for the sole use of the intended recipient(s). It may contain information that is privileged and confidential.  Any unauthorized review, use, disclosure, or distribution is prohibited. If you are not the intended recipient, please delete this message, and reply to the sender regarding the error in a separate email.
>>>>>>> _______________________________________________
>>>>>>> NSRCA-dist8 mailing list
>>>>>>> NSRCA-dist8 at lists.nsrca.org
>>>>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-dist8
>>>>>> _______________________________________________
>>>>>> NSRCA-dist8 mailing list
>>>>>> NSRCA-dist8 at lists.nsrca.org
>>>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-dist8
>>>>> _______________________________________________
>>>>> NSRCA-dist8 mailing list
>>>>> NSRCA-dist8 at lists.nsrca.org
>>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-dist8
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-dist8/attachments/20211025/1135c0f1/attachment.html>