<html><head><meta http-equiv="Content-Type" content="text/html; charset=UTF-8"></head><body><div><font face="sans-serif">What are the other settings? </font></div><div><font face="sans-serif"><br></font></div><div><font face="sans-serif">Specifically check - </font></div><div><font face="sans-serif">Software is 4.22, or higher</font></div><div><font face="sans-serif">Low timing</font></div><div><font face="sans-serif">8khz pwm</font></div><div><font face="sans-serif"><br></font></div><div><font face="sans-serif">And.... All solder joints and connectors are healthy. </font></div><div><font face="sans-serif"><br></font></div><div><font face="sans-serif">Possibly try reloading software...not likely to help, but it might. </font></div><div><br></div><div id="composer_signature"><meta http-equiv="Content-Type" content="text/html; charset=UTF-8"><div style="font-size:85%;color:#575757">Regards,</div><div style="font-size:85%;color:#575757"><br></div><div style="font-size:85%;color:#575757">Dave</div><div style="font-size:85%;color:#575757"><br></div><div style="font-size:85%;color:#575757">Sent from my Sprint Samsung Galaxy Note5.</div></div><div><br></div><div style="font-size:100%;color:#000000"><!-- originalMessage --><div>-------- Original message --------</div><div>From: Olstinske Dale via NSRCA-discussion <nsrca-discussion@lists.nsrca.org> </div><div>Date: 11/1/17 3:59 PM (GMT-05:00) </div><div>To: General pattern discussion <nsrca-discussion@lists.nsrca.org> </div><div>Subject: [NSRCA-discussion] Castle settings </div><div><br></div></div>I have an Edge 80 HV Esc, Plettenberg Advance motor. I usually need around 70-75 A to get good performance, but I can’t get more than 60A from this one. I’ve recalibrate the throttle (fixed end points) but no improvement. Wondering if there is some other setting causing this?<br><br>Thanks,<br><br>Dale<br><br><br>_______________________________________________<br>NSRCA-discussion mailing list<br>NSRCA-discussion@lists.nsrca.org<br>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion</body></html>