<html><head><meta http-equiv="content-type" content="text/html; charset=utf-8"></head><body dir="auto"><div>You can get the leads ready to splice from revelectrics. </div><div id="AppleMailSignature"><br></div><div id="AppleMailSignature">Verne<br><br>Sent from my iPhone</div><div><br>On Apr 12, 2016, at 3:08 PM, Ronald Van Putte via NSRCA-discussion <<a href="mailto:nsrca-discussion@lists.nsrca.org">nsrca-discussion@lists.nsrca.org</a>> wrote:<br><br></div><blockquote type="cite"><div><meta http-equiv="Content-Type" content="text/html charset=utf-8"><div class="">The Cellpro 10XP and Turnigy 10XC (when they were available) chargers used what I <u class="">think</u> was a JST PA connector to plug into the charger. I want to make some new extensions that will plug into the charger and have 5S JST XH balance connectors on the other end. </div><div class=""><br class=""></div><div class="">I previously cut the connector/lead off the part of the balance board that I didn’t use and soldered the leads to a 5S JST XH balance connector lead. However, I don’t want to buy more balance connector boards just to get the connector/lead to plug into the charger.</div><div class=""><br class=""></div><div class="">Does anyone know where the JST PA connector/lead can be purchased? Or better yet, does anyone know if I can buy what I need without all the soldering?</div><div class=""><br class=""></div><div class="">Ron Van Putte</div></div></blockquote><blockquote type="cite"><div><span>_______________________________________________</span><br><span>NSRCA-discussion mailing list</span><br><span><a href="mailto:NSRCA-discussion@lists.nsrca.org">NSRCA-discussion@lists.nsrca.org</a></span><br><span><a href="http://lists.nsrca.org/mailman/listinfo/nsrca-discussion">http://lists.nsrca.org/mailman/listinfo/nsrca-discussion</a></span></div></blockquote></body></html>