<html>
<head>
<style><!--
.hmmessage P
{
margin:0px;
padding:0px
}
body.hmmessage
{
font-size: 10pt;
font-family:Verdana
}
--></style>
</head>
<body class='hmmessage'>
I have been "building" my first pattern airplane, a CARF Integral, and I have found a good use for a pin vise I thought I would share. These thin skin composite aircraft make using a drill overkill, but a dremmel also tears the daylights out of everything too. So, since the shafts of the routing bits, sanding bits, etc.. are small enough to fit in the pin vise, I have been using that to route out holes, slotting the skins for the control horns, etc... by hand with much better and cleaner results. Just thought I would pass this on.<BR>
<BR>
Mike C<BR>
D4<BR> <br /><hr />Hotmail: Free, trusted and rich email service. <a href='http://clk.atdmt.com/GBL/go/201469228/direct/01/' target='_new'>Get it now.</a></body>
</html>