<table cellspacing="0" cellpadding="0" border="0" ><tr><td valign="top" style="font: inherit;"><DIV>I think I read somewhere that the R608FS receiver uses the same chipset and has the same problem.</DIV>
<DIV> </DIV>
<DIV>So far I have not had any problems with the servos that I use, but I was not able to check the pulse width out of the higher channels with my Hitec programmer. I have to wonder, however, exactly what is the logic level for the various servos? Also, does the logic level of the servo change with a different battery voltage? Does the output level from the rx change with a different battery voltage?</DIV>
<DIV> </DIV>
<DIV>I guess this is a good reason to use some sort of output conditioner (powerbox, etc) if mixing brands of receivers and servos.<BR></DIV>
<DIV>Bob R.</DIV>
<DIV> </DIV>
<DIV><BR>--- On <B>Fri, 11/21/08, MKMSG <I><mkmsg@cox.net></I></B> wrote:<BR></DIV>
<BLOCKQUOTE style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: rgb(16,16,255) 2px solid">From: MKMSG <mkmsg@cox.net><BR>Subject: [NSRCA-discussion] Futaba R6014FS Receivers<BR>To: "NSRCA Discussion List" <nsrca-discussion@lists.nsrca.org><BR>Date: Friday, November 21, 2008, 1:15 AM<BR><BR>
<DIV id=yiv1661051185>
<STYLE></STYLE>
<DIV><FONT face=Arial size=2>I was reading the FAQ section of the Futaba website when a particular item caught my eye regarding the R6014FS 2.4 receiver. The FAQ states that <FONT face="Times New Roman" size=3>the use of non Futaba digital servos with the R6014FS receiver may be problematic due to the 6014's lower output voltage of 2.7 volts. Since I do occasionally mix and match Futaba and JR servos and use the 8 channel 2.4 receiver, I wondered if this issue was common to all Futaba 2.4 receivers. Here's Futaba's answer: "The FAQ refers only to the R6014FS receiver, this is the only one that has the lower voltage." Just thought I'd pass this along in case someone experiences performance anomalies with the 6014 receivers using other than Futaba servos.</FONT></FONT></DIV>
<DIV><FONT face=Arial size=2><FONT face="Times New Roman" size=3></FONT></FONT> </DIV>
<DIV><FONT face=Arial size=2><FONT face="Times New Roman" size=3><FONT face=Arial size=2>Mike</FONT></FONT></FONT></DIV>
<DIV><FONT face=Arial size=2><FONT face="Times New Roman" size=3><FONT face=Arial size=2>NSRCA 35</FONT></DIV>
<DIV><BR></DIV></FONT></FONT></DIV><PRE>_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion@lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion</PRE></BLOCKQUOTE></td></tr></table>